Rolling Pin Grip

Rolling Pin Grip made specifically for this Rolling Pin found on Amazon <-- CLICK!

It may fit other rolling pins that have a metal rod going through the mail rolling part, however our Grip has only been tested on this specific Amazon Rolling Pin.

1. Simple take apart your rolling pin by removing the handles by pulling them away and turning at the same time.

2. pull metal rod our from rolling pin

3. remove plastic end caps on rolling pen from both ends

4. insert the rolling pink grip rod through the end of the rolling pin

5. the 3d printed end caps will go inside each end of rolling pin

6. add back the washer and nut and tighten the nut all the way down

DO NOT SPRAY PAINT THE METAL THREADED ROD.

TAPE OFF THE 3D PRINTED INSERT SO THAT EPOXY DOES NOT GET ON IT.  

IF IT DOES, YOU WILL BE SAD!

Join our Facebook Group